Graphtec CB15U-K30 1.5mm 60° Cutting Angle Blade 2-Pack (for CB15 Blade Holders)

Graphtec CB15U-K30 1.5mm 60° Cutting Angle Blade 2-Pack (for CB15 Blade Holders)

This model is an optional blade for all Graphtec roll fed and flatbed cutters using the Red-Tip CB15 blade holder. "U" blades have a standard tip design for general purpose cutting of standard vinyl materials. These are sometimes referred to 30-degree blades in reference to the blade tip angle, however the cutting angle is 60-degrees which is consistent with other industry blades measured at 60-degrees for cutting thicker types of materials. The CB15U-K30 is a Supersteel Blade made for cutting rigid and otherwise difficult to cut materials ranging from 0.25mm to 0.5mm (9mil to 20mil) thick. Recommended blade for sandblast media (rubber or vinyl) and reflective vinyl sheeting.

Graphtec Part Numbers:
2 Pack 60° Cutting Angle Supersteel Blades: CB15U-K30-2

CB15U-K30 blades are compatible with the optional Graphtec CB15 1.5mm Red Top Blade Holder for CB15 Blades, or the Graphtec Red Top Brass Tip Blade Holder for CB15 1.5mm Blades (sold separately).

These blades do not include springs needed for older style blade holders, and USCutter cannot confirm compatibility with other than the two aforementioned models.