Roland DTF Powder for BN-20D

Roland DTF S-Powder for BN-20D

Roland DTF powder comes in a 1 Kilogram pouch which is enough powder for approximately 200 transfers.

1. Print to film with the BN-20D and S-PG inks, on S-F164 transfer film.
2. Apply shaking powder over the ink using S-POWDER.
3. Melt powder under heat press at recommended time and temperature.
4. Heat press design to your fabric and remove the film backing.

Roland S-Powder Curing Instructions:

Place the S-F164 film inside a heat press, hovering and not applying pressure. (Stahls’ Hotronix Hover Press is recommended.) A 4 to 7 mm gap between the film and the heat press top plate is recommended, for 3-5 minutes at 285°-300°F. Do not completely close the press.