EP36 36-inch DTF Powder Shaker Oven – 110v with Auto Powder Recirculation (White)

EP36 36in DTF Powder Shaker Oven – 110v with Auto Powder Recirculation

Best energy efficiency compared to any other 36-inch powder machine

The EP36-110 is the most energy-efficient 110v powder shaker on the market, bar none. This is the ONLY fully automated powder shaker that can cure up to 55 linear feet (17 linear meters) per hour of 36-inch DTF film and achieve this on a standard USA home 110 volt 15-amp circuit. 

Total curing coverage area reaches 165 square feet /15.3 square meters per hour

This DTF powder shaker is perfectly matched with the output speeds to the EPSON G6070 printer and similar speed 36-inch DTF printers.

Other 36-inch powder machines may advertise 110v operation at a slower rate, but even then, they will require a 20-amp circuit, which means an expensive electrician needs to be called in. Also, higher power consumption means more costly energy bills.

Intelligent controller

To achieve maximum energy efficiency, the EP36-110 has an advanced motherboard with next gen firmware that goes far beyond simply turning the heating elements on/off based on a trip sensor watching film movement. The intelligent controller monitors temperature and multiple sensors and turns on only the required elements needed to achieve and maintain optimum powder curing. A built-in safety mechanism is a watchdog that disables the heating elements to protect the film from burning if the printer stops for any reason.

Touch screen

As you might expect from state-of-the-art technology, there is a touch screen with an intuitive and simple to understand user interface that allows full control of all important system elements.

Auto powder recirculation

Users will appreciate the auto powder recycling system that replenishes powder back into the top hopper, as well as the auto-advance-film link feature that can be engaged to continue to cure the last part of the film when cut away from the printer at the end of a job session. No need to waste extra film or attach weights and hand-hold the last stretch of film that needs to be cured.

Unlike less sophisticated systems that pull film from the take up reel, the EP36 utilizes a vacuum to carry the film through the shaker, thus providing two advantages over other systems:

• 1) Film can be cut from the printer exit tray at the end of the day and it can still be fed/cured through the shaker at a steady rate.
• 2) Film can be cut and removed immediately after curing just before the take-up roll, which is useful for cases when your customer is asking for a rush job that would otherwise have to wait for the end of the day to be removed from the take up reel. This allows the printer to keep running non-stop and the additional film to be easily attached to the rest if the film already on the take up reel.

Best energy efficiency compared to any other 36-inch powder machine, intelligent controller, touch screen, auto powder recirculation, end-of-roll auto-advance, effective air filter with no need for external fume extractor and so much more - for those looking for the most cost effective shaker and lowest total cost of ownership, there is no better choice that the EP36-110.

Want to save even more money on energy efficiency? Consider using Gallery DTF Extra Fine Powder. The lower melting point of Gallery DTF powder allows you to turn down the curing temperature of the shaker oven and also allows you to heat press prints at a lower temperature, minimizing heat press marks on performance garments.